I think if it’s becoming noticeable to you, then it’s worth sending to Rolex, presumably under the 5-year warranty. If you are close to St James they used to be very helpful for drop in enquiries.
I have a MN22 FXD which I’ve owned from new. Poor strap longevity aside, I love the watch - the design, comfort and military association all add up to a cool timepiece.
I’ve worn mine as part of a rotation for over a year now and it spends a fair bit of time on a winder. Timekeeping was very accurate for the first few months - it would lose about 5s a week which is impressive.
Over the past few months I’ve noticed the timekeeping slipping significantly - it’s now losing 7-8s per day - not anything to cry about, but out of spec and poor for this movement. It also takes a lot of shaking to get going once the PR has been drained and doesn’t seem to respond particularly to manual winding.
Is this normal for a MT5602 movement or do I have a bad one? Has anyone else experienced poor performance from their FXDs?
Sent from my iPhone using Tapatalk Pro
I think if it’s becoming noticeable to you, then it’s worth sending to Rolex, presumably under the 5-year warranty. If you are close to St James they used to be very helpful for drop in enquiries.
I have a BB58 that I wore more or less daily for 18 months and the same thing happened. Sorted eventually in 2 visits to my AD - first time it came back with very rough hand winding, second time it seems to be okay, although I’ve not worn it much recently
I just did this myself with my Tudor…dropped off, serviced under warranty and delivered back to me in 10 days…and that included a bank holiday monday too so would definitely recommend giving it to them if the accuracy has dropped off, you won’t be without it too long.
Sent from my iPhone using Tapatalk
Indeed - it’s running at a consistent -8s / day which is not the end of the world. If it was +8s I’d probably be fine with it!
I don’t think the MT5602 is a straightforward movement to regulate. Has anyone had an experience with it? Is it like the Omega co-axials that need a special tool?
Sent from my iPhone using Tapatalk Pro
Yeah, that’s further out from COSC than if it had been +8s.
If it’s in warranty, not sure I’d worry about the complexity of regulating or servicing…it would be going back to Tudor. For me, even outside warranty that kind of thing doesn’t really cross my mind as I’d just send it to the manufacturer.
Well I can live without it for a couple of weeks - just a bit poor considering the rave reviews I’ve read of this movement. Can anyone recommend a good AD near Essex?
Sent from my iPhone using Tapatalk Pro
My BB Pro is supposed to run between -2 and +4. It ran -4 last night which got me wondering, do they care about the average of various positions or is it enough that it's consistently out of spec in one position?
And can I just stroll into any AD I like or do I have to go to the one I bought from? Do I need anything other than the watch and warranty card?
Obviously, I'm going to check a few more days and positions but the only reason I checked it in the first place was because I think it's losing more time than it should do over the course of a week (30-40s).
As well as slipping time, mine doesn’t auto wind very easily on the winder and stops if I’m not having a particularly energetic day!
Will aim to drop it in to my local AD in the next couple of weeks.
Sent from my iPhone using Tapatalk Pro
Fwiw I have two FXD and have found each to be very accurate, no noticeable loss or gain, and I do check my timekeeping. To qualify that a little, I would seldom wear any watch for more than a week at a time.
Sent from my Nokia 1.4 using Tapatalk