After seeing Sickies post about removing a scratch form a sapphire crystal I thought I'd give it a go myself on my Plant Ocean. Have had a scratch on the crystal for a while now, think it was my wife's diamond engagement ring that did it....not sure how mind. Anyway, ordered a cheap Tack Life Dremel type tool off Amazon and some Scratch Genie diamond polishing paste. Taped up the bezel and away I went, 5 mins later this is the result....
Scratch visible around the 10 and 11 markers:
After 5 mins of polishing:
All I can say is I wish I'd done this sooner🙄
Great result for a small outlay.
Thats a really good result. Fair play for being brave enough to try it
Is there no AR coating on the outside of the Omega's crystal, or did you have to remove that first?
Does this work only for sapphire? how do you know what Chrystal you have? I have marked one of my Meters First and its bugging me.
That's an excellent result! Well done.
MCFastybloke - a Rolex? If it's flat, then it's sapphire, so it's polishable. I am going to claim that I started the trend, back in 2007!
https://forum.tz-uk.com/showthread.p...hlight=diamond
Many thanks . Also apolgies for the drift to the OP
Top job, the taclife is exactly what I used.
It's really surprising how good the stuff is, I've since done a Davosa which was also scratched & the same result, totally mint now.
Sent from a technical device.
I think you need to use a rotary tool, in all honesty, I doubt that you will be able to get the deep scratch out by hand,
If you don't want to buy one let me know as I might have another one lying about that you could have.
Sent from a technical device.
Last edited by sickie; 18th August 2022 at 20:41.
Great work OP! I took a rotary tool to a Sinn 656 I had back in 2006. The external AR had started to come away in very small linear flakes so I removed it all and polished the crystal. I'm afraid the pictures perished in the Photobucket dabacle and the watch is long gone, both it and a UX went when I moved to Damasko.
https://forum.tz-uk.com/showthread.p...hlight=dremmel
Last edited by magirus; 18th August 2022 at 20:45.
F.T.F.A.
People using rotary tools for this, what sort of RPM does the job without causing any damage? Do you need to start/stop to avoid heat buildup?
I don't know what the speed was but using the taclife It has 3 speeds and I used the middle setting. Move around the crystal so heat dosn't build up but also I stopped then checked It every minute or so.
I'm guessing but I think the speed was around 2 -3000rpm, also I didn't use great pressure, just enough so it wasn't slowing down the tool which dosn't take much.
Sent from a technical device.
Does this work on Seiko crystals? Where does the paste come from?
That's great OP, thanks for posting. Tempted to do this to my U1, I'd like to get rid of the external AR.
Another question if I may be so bold.
Is the genuine Dremel better than most of the similar looking models?
I have just resurrected this thread to find out if anyone else has tried to polish their Rolex crystal lens and, if so, how did they get on.
I have an Explorer1 from 2014 and a couple of scratches have appeared so I am itching to give it a go.