I had a pam24 and it wouldn’t wind in a watch winder.
Hi i have a pam 25 submersible with a calibre op 111 movement
My problem is the watch stops after a few days in my watch winder all my other watches keep great time in the winder
Ive had it serviced and rechecked but the problem is still there
When i wear it is fine
I replaced my winder box when this first occurred and with my new barrington winder it still happens any idears
Sent from my iPad using TZ-UK mobile app
I had a pam24 and it wouldn’t wind in a watch winder.
Can that model wind in both directions? Is your winder set to the correct TPD? What direction are you winding it?
Sent from my SM-N960F using Tapatalk
Last edited by Arcam; 14th July 2019 at 10:09. Reason: Typo
Yes it winds both ways all motors set to 650 tried the panerai on 750 no difference its bizzare its the only one of 6 watches that does this
I move the watches about still after a few days it stops
Sent from my iPad using TZ-UK mobile app
‘Move the watches about’ - do you mean different position in the winder? Think Barrington winders have watches vertical (unlike some other winders), can you alter the angle?
The watch face must be vertical (slightly laid back will also work) to wind, don't change the positions on the winder as it will not get the correct number of tpd, most winders do an on/off cycle, some are off for up to 12 hours to allow the watch to wind down.
Can your winder go to 900 or higher?
Sent from my SM-N960F using Tapatalk
Last edited by Arcam; 14th July 2019 at 13:06. Reason: Typo
I had a 329 ,and that seemed to stop when it was on the watchwinder,I thought it was the cheap winder that wasn’t working right .
The watch was perfect on the wrist .
Sent from my iPhone using Tapatalk