I have a few, will check the measurements and report back as soon as I can.
Gadget
I have a working ETA2824 movement with a very nice dial and hands with BWG9 lume .Now I'm looking for a diver type case to fit this assembly. The dial is I believe 29.5 mm.There are some on Ebay but they seem to be for a larger dial .If I can't get a case I shall probably sell the movement and dial which is a shame .
Any suggestions ?
I have a few, will check the measurements and report back as soon as I can.
Gadget
The Zenith Porto is 30mm and the chrono is 29.8mm the other two are 28.5mm and thats all i have ;-)
Thanks for replying.
Do these measurements refer to the dial size ?
I just checked ,my dial is 28.9 actually and of course I would need the holding ring (if that is the correct term )
I was going to say... make sure whatever you buy either has a movement ring / holder otherwise some trial and error with Soares will ensue...
Can you post a picture of the dial etc - just suggesting a case would be easier once the dial design is known
Sent from my Pixel 2 XL using Tapatalk
This is the dial
https://www.ebay.co.uk/itm/DIAL-HAND...r=583398968753
it's on a 2824 movement now .Movement runs fine but there is a little slippage when hand winding .I can live with that .