Picture of the movement or calibre please.
Sent from my SM-G900F using Tapatalk
Does anyone have a source for spares on an Ingersoll Midget pocket watch? I need a new balance shaft and can't find a supplier.
Thanks
Picture of the movement or calibre please.
Sent from my SM-G900F using Tapatalk
I don't have anything that looks quite like it but ofelten the finish is different for the same basic movement.
I can measure the staff and find one of very similar, if not of identical dimensions.
Sent from my SM-G900F using Tapatalk
I have something similar with the old cone type staff, so if the length is measured post the size here and I will see if it is the same.
Can't measure the staff as it's still attached to the cock.
It has cone shaped ends, but this is a little different to the Ingersoll.
- - - Updated - - -
Can't measure the staff as it's still attached to the cock.
It has cone shaped ends, but this is a little different to the Ingersoll.
If it has cone ends it can't be broken can it ?
The female cones it fits into may have come loose and it has popped out from them.
5 min job long as the hairspring is ok.
Send it to me if you like. If not cones I may have one of the right dimensions.
Sent from my SM-G900F using Tapatalk
Last edited by Webwatchmaker; 24th June 2018 at 18:49.
Brendan, McMurdo is the guy who needs the watch sorting out mate.
Thanks webwatchmaker. If you message me with your address then I'll send it to you for assessment.
On my website under contact:
www.webwatchmaker.com
B.
Sent from my SM-G900F using Tapatalk
That's good news. They do pop out if dropped or knocked hard.
Shouldn't be too difficult to put it back.
Sent from my SM-G900F using Tapatalk