If it's anything like the Zenith Rainbow it needs (careful) force to push the pins right through
jpg imagescertificity.com
As you can see the bracelet is attached to the case by solid pins and not spring bars?
Is there a special way to remove these or just forcefully push them out?
Thanks in advance.
If it's anything like the Zenith Rainbow it needs (careful) force to push the pins right through
I wouldn't know on a Blancpain, but I have a Swatch with solid bars for the strap and they just push out, with some force, getting them out is also much easier then getting them back in. Reason being, with my uncoordinated hands anything I've used to push the solid pins back in has slipped either scratching the case or sticking into my flesh.
This might be of use, post #6
http://forums.watchuseek.com/f222/ho...s-3202298.html
Something like this would do it
Stunning watch.
As you can see the bracelet is attached to the case by solid pins and not spring bars?
Is there a special way to remove these or just forcefully push them out?
Thanks in advance.[/QUOTE]
.12345
Last edited by jambobbyb; 22nd May 2019 at 09:25.
pin driver, jewellers hammer and lots of little/gentle taps, Tutima miltary watches are similar
Thanks everyone so much for the input
Is going on a strap