Right chaps, need some help on a FE 4611 movement, anyone worked on one or know of the one in question??.
It came to me with the stem disengaged, i need to refit it but its just not locking in??.
Normally there is a visible pusher to engage or disengage but i dont see it on this one although there are two screws around the stem hole on the base of the movement.
Heres a couple of pics i borrowed from the seller, just for reference.
Would really like a bash at this tonight if anyone has any ideas?
Cheers,
James.
Doesn't show on the Ranfft photo you included but there's a screw just below the stem when viewed from the back and the stem at 3.
Loosen this gradually while pulling gently on the stem, should need no more than one to one and a half turns. DO NOT turn it more than needed else you will need to strip the keyless works to put the set lever back on.
Hi bud,
I have been messing around with it and managed to do so, then checked back here and seen your reply. You are correct, lysander informed me of similair today but i was'nt sure which screw although under a loupe it became clear which screw had slight tool marks.
Thanks for the help, its appreciated.
James. :D
Posting Permissions
Reply With Quote