Post-service run in period ?
After my various posts re Seamaster back from Brendan Hoey service, what is the concensus with regard to whether watches require a run-in period after service ?
My SMP was running around +12s p/d pre-service and, although have not properly checked, have a nasty feeling that it's now running slow, I daren't do a proper check just yet, was thinking of giving it a week of daily wear to see if it settles down.
Any opinions on this or first-hand experience of the Cal. 1120 SMP would be appreciated.
Gomers
Re: Post-service run in period ?
IMO a watch should be within spec straight from service, after all regulation is part of the service.
cheers
mike :wink:
Re: Post-service run in period ?
There is no such thing as a run in period in my experience. Watches will slow down with time as lubrication evaporates and dries out until a new service is needed. Shock and magnetism have far more influence over the running of the watch if it was properly timed and adjusted in first place.
Re: Post-service run in period ?
Agreed - run in time should not be needed.
Check it against an accurate clock suggest start and end of day while worn and then overnight while not worn.
Re: Post-service run in period ?
Although run-in time is often derided as a myth, it happens nonetheless. The ETA2824 I have fitted to my watches are timed on a timing machine to run, on average, 20 seconds a day fast "out of the box". It is a fact that this rate slows by a few seconds a day over a period of just a few weeks. Now whether a watch which has already been run-in doesn't need to be run-in again following a service, it's something I haven't studied.
Eddie
Re: Post-service run in period ?
Breitling told me that it can take a couple of weeks for my Chrono Avenger to settle into running at acceptable levels and they were completely right, if I remember it took about two or three weeks to settle down.
Re: Post-service run in period ?
Shouldn't the timekeeping be checked by the repairer after the service and before return?
Re: Post-service run in period ?
I am sure a run-in period is needed for a new movement, or for movements with new components.
You should not need a run-in period for a movement that is already run-in, and has only been serviced.
Pete
Re: Post-service run in period ?
i would say the timing on the bench and the timing on the wrist can be two different things, give it a week to bed down and then if its beyond acceptable levels, back to the servicer.
Re: Post-service run in period ?
I have previously found when buying new and therefore it is my opinion rather than fact that watches left for a while in stock and not run take a little time to settle - but all my Chronometer watches that have come back from a service were running within COSC, one a little slow - now when I send a watch for service I state I don't mind if it runs slightly fast - but I don't want it to run slow.
Re: Post-service run in period ?
I always give a watch at least a days running after service before attempting proper regulation.
The standard method of lubrication for some parts (mainspring for example) involve applying small lines of lube that get distributed properly to the inaccessible areas during initial use. If I put a movement on the analyser immediately after servicing the results will be significantly different from those achieved after a couple of power cycles have distributed the lube properly.
Re: Post-service run in period ?
GeoffD,
When are you available to sort my Seamaster please ? :wink: Only half joking !
Re: Post-service run in period ?
