They should be sourceable somewhere or have a batch made.
The bracelet for for my Ti RT Airspeed was missing the safety bit from the clasp. I have sourced a generic clasp and pinched the safety bit from that. However the pin that secures the clasp to the bracelet is now too short (I can only presume that when the safety bit went missing the existing pin was shortened). The RT pin is in two equal parts with male and female threads where they meet. I could use the pin that came with generic clasp but this is of the tube and plug form (and is actually too long and will need shortening). Is it possible to get the RT type ones that are threaded in the middle as this seems like a much better solution that can be removed without having to grind off one of the heads.
Thanks.
Last edited by Jeremy67; 9th July 2023 at 10:06.
They should be sourceable somewhere or have a batch made.
Something like these, possibly?
https://www.cousinsuk.com/product/un...0100-to-0150mm
Just measured the safety clasp screwed pin on my own RT Ti Airspeed:
Screw head diameter = 1.8mm
Tube diameter = 1.4mm
Tube length = 20.5mm
So L40145 should do the trick, depending on how big the holes are in your replacement safety clasp :)