I have the following which I really like. In an ideal world, I would replace the bezel with a new one but I cannot seem to find one.
So the next thought is to rebrush the existing one and have the bezel reprinted. Has anyone had this done with any success? Any pointers would be appreciated.
To clarify, the original bezel was printed rather than engraved.
Last edited by Tahiti; 21st February 2015 at 23:14. Reason: adding direct pics
Not sure how possible this is, but what about getting a template laser cut from adhesive vinyl and then brushing or spraying a decent enamel paint over it?
http://www.lasercutit.co.uk/signage-...-stencils.html
Ofrei have spares but make sure you're sitting comfortably.
http://www.ofrei.com/page663.html
Omega Bezel 082TZ0010 For Case 198.029OME-082TZ0010
Omega Bezel for case number 198.029 Special order item, allow 3 to 5 weeks for delivery.
$530.00
Thanks for the thoughts.
As for Ofrei. Crikey.
I once printed a bezel onto self adhesive vinyl and stuck it on.
Did it look any good and did it last?
If it's a simple design, could you ???
1 remove it
2 refinish
3 take to an engravers to have design cut in
4 fill in the engraving with paint
You could, but I was really looking for an original as possible look. The original is printed (for want of a better description) rather than engraved and filled on this particular example.
A new one is available at Ofrei .But it cost $500 or more . I have three bezels and two watches from this model . I am thinking if i could have them laserprinted somewhere .Or if i could have at least one of them cut with a cnc machine .And then fill in the numbers and indicies with black paint . Just to make it look like a original print . If i get someone to do would there be any interest for doing more of this?
Last edited by rogart; 19th November 2015 at 14:04. Reason: wrong spelling
Personally, I'd like it to look (or to be) factory original looking, but for the time being, it looks as it does in this photo which is not ideal so I may consider doing something if the finish (and cost) is good.